snap on modis ultra pass through ecm programing

* Additional Requirements: Reflashing software application, data subscription from OEM and a PC with Internet access. The interface connects to a PC (not included), and to the vehicle through the OBD connector. Pass Thru Pro IV includes the necessary software device drivers, and the vehicle communication interface. Upgradable through user-installable software. Meets SAE J2534 reprogramming standards which are required standard for every auto sold in the US since model year 2004. Pass Thru Pro IV can program emission-related ECUs on any J2534-compliant vehicle, using software provided directly from automotive manufacturers.* Meets SAE J2534 reprogramming standards which are required standard for every auto sold in the US since model year 2004.Ĭompatible with SAE J2534-1 and J2534-2 including 04.04 and v500 API reprogramming standards for every automaker. Pass Thru Pro II can program emission-related ECUs on any J2534-compliant vehicle, using software provided directly from automotive manufacturers.

Fix software-controlled driveability issues and emission issues, program new ECUs. The programming device that comes with it also supports J2534 pass through which has been very helpful for software updating. Replace the existing software/firmware in electronic control units (ECUs) with updated OEM software. For programming with SPS on the bench, is possible to do it easy on the PCM modules, as they can be connected standalone. In short Honda diagnostic tool reads the key codes from the immobilizer unit around the ignition barrel and writes them to the ECU. This information is provided on an as is basis. This can be caused by a non-GM calibration programmed into the control module or an incomplete SPS data record. Hondata cannot provide any assistance with the immobilizer programming process using the Honda HDS diagnostic tool. OEM-level reprogramming brought to the independent shop. The programming process uses Pass-Thru Programming through the Multiple Diagnostic Interface tool (MDI/MDI 2). SAE J2534 Compliant Programming Interface

Snap on modis ultra pass through ecm programing